BUTTON CONTROLLED I2C DATA TRANSFER
A- In this LAB, you will use
Arduino-Uno Arduino Base
Shield
Grove Button Grove LCD
Screen
I. Connect Arduino base shield to Arduino Uno.
II. Grove Button should be connected to any digital interface of base shield.
III. Grove LCD Screen communicates with Arduino via I2C.
Useful information:
https://wiki.seeedstudio.com/GroveLCD_RGB_Backlight/
https://wiki.seeedstudio.com/Grove-Button/
B- Program the microcontroller by using C programming on Arduino IDE.
When your program runs, it should do the following task.
I. At the beginning, “Hello” message should be displayed on LCD Screen.
II. Number of button presses should be displayed on LCD display. If
there exists 5 presses in 3 seconds, the number on LCD display should
be set to 0.
